INTRODUCTION
You might be wondering why there are several projects which are not completely done.Well,there are several reason why this happens.It might be out of budget or not properly planned.So,this lesson well help you achieve the desired quality project.
A project plan is necessary before undertaking any project because it serves as your guide in accomplishing an activity.It well give you an idea what needs to be done,how much to spend and what procedures to undertake.A well prepared project plan saves time and cost of materials.Below is a sample project plan of an extension cord.this format can also be used in preparing a plan for other projects in the future.
PROJECT PLAN-(MAKING AN EXTENSION CORD)
Name of group:SALVE JANE JUDICPA,ANNIE PON-AN,MYLENE BENES,JOHN BLAS ESCOTE,ZER JOHN MATILLANO,NIKO APOLINARIO
Year & Section:GRADE 8-GARNET
I.Name of project:Extension Cord Assembly Date Started:01/10/17
Date Finished:01/10/17
II.Objective:
a.Demonstrate how to make an extension cord.
b.Observe safety measures while doing the project
III.SKETCH/DRAWING:
IV.MATERIALS NEEDED:
Qty.Unit Description Unit Cost Total Cost
1 pc. Convenience Outlet (surface type duplex) Php 29.00 Php 29.00
3 meters Flat Cord #18 AWG Php 12.00 Php36.00
1 pc. Male Plug Php 15.00 php 15.00
TOTAL COST OF MATERIALS Php 80.00
+ cost of labor (approximately 20%-30% of cost of materials) (30%) Php 28.00
SELLING COST PHP 122.00
Sample Pictures of Materials Needed
Flat cord Male plug
EYELET WIRE CONNECTORSS
Convenience outletV.TOOLS AND EQUIPMENT NEEDED:
1.Standard/Flat screw driver
2.Philips screw driver
3.Long nose pliers
4.Side cutting pliers
5.Electrician's knife/pocket knife
6.Continuity Tester or Multi-tester
VI. PROCEDURE:
1.Prepare the plan
2.Gather all necessary materials,or tools and equipment needed.
3.Insert cord into the male plug,spit the cord wires about 8 cm long.
4.Remove insulation of both wires 1-cm-long with a pocket knife as if sharpening a pencil.Be careful not to cut any strand.
5.Scrape bare wire with the back of the knife until shiny twist the wire strands.
6.Tie the underwriters knot
7.Make a loop on terminal wires and connect the wires to the screw of the male plug.The loop should go with the thread clockwise direction.
8.Split the cord wires at the other end about 4 cm long, then follow procedure no. 4.
9.Connect the wires to the connectors.
10.Open the convenience outlet then remove the screw.
11.Insert the wire connectors to the screws, tighten it and return the cover.
12.Check the continuity and test the extension cord.
